|
|
|
Discussion Forums
Forum Index
> Rifles general discussion
> Resizing Magnum Brass
Resizing Magnum Brass
@ 07:54 am (GMT) |
Paul LevermanJust wondering if anyone else is using the collet die from Innovative Technologies? I've used it for years on my hunters, and haven't seen any negative results as yet. The concept has merit, this die sizes the area just above the belt, not the shoulder. My cases still headspace the same as when I neck size, and I only have to use this die maybe on the third or fourth reload.The link below will take you to his site and if you scroll down to the third section, you will see the die and the info for it. http://www.larrywillis.com/ |
Replies
@ 10:12 am (GMT) |
Andrew MurrayRe: Resizing Magnum BrassSounds good. What calibre are you using it for?Last week I saw some brass 24 gauge shot guns shells resized for a Martini-Henry. The bloke said he got them out of the USA. Necked down about halfway along the case. |
|
@ 07:02 pm (GMT) |
Paul LevermanRe: Resizing Magnum BrassHey, Andrew. I use it on the 338WM and the Norma. After forming the Norma from 300WM, I run them through this die just to make sure. Like I said, on the 338, it's about every third or fourth reloading.The 577-450 is an odd sort of duck. Must have been accurate, look at the length of the neck for guidance![b] |
Please wait
ABOUT USWe are a small, family run business, based out of Taranaki, New Zealand, who specialize in cartridge research and testing, and rifle accurizing.
|
KNOWLEDGEBASE |
KNOWLEDGEBASE |